Storage & Care Guide

🧴 Resources · Guide

How to store transfers you haven’t pressed yet, and how to care for finished products so they last.

Keep transfers flat or loosely rolled — avoid tight folds, which can crack the print.
Store in a cool, dry place out of direct sunlight. Heat and UV exposure can weaken adhesive over time.
Keep transfers in their original packaging or a sealed bag until you’re ready to press — dust and moisture can affect adhesion.
Stored properly, unused transfers hold their quality for months — no rush to use them all right away.

Wash inside-out in cold water for the longest-lasting print.
Use a gentle or hand-wash cycle where possible — heavy machine cycles wear prints out faster.
Avoid bleach or fabric softener directly on the printed area.
Air dry or tumble dry on low heat. Skip high-heat drying — it’s the single biggest cause of premature cracking or fading.
If ironing the garment later, iron inside-out and avoid direct heat on the print.

⭐ Expected durability: 50–100+ washes when pressed and cared for correctly

Once applied, avoid touching or pressing on the design for the first 24 hours to let the adhesive fully set.
Clean gently with a soft, damp cloth. Avoid abrasive scrubbing or harsh solvents.
PermaStickers are scratch- and weather-resistant, but aren’t rated for mission-critical or extreme-wear surfaces.
Best suited to smooth, rigid surfaces — glass, metal, hard plastic, wood. Not recommended for fabric, leather, or stretchy/flexible materials.

📄

Printable Storage & Care Guide
Questions about a specific product or surface? Message us on WhatsApp or email dtf@pparuba.com.